Classic AutoAir Perfect Fit-Elite Series Provozní pokyny stáhnout pdf (Strana 7)

Pull lower edge of the dash towards the rear of car to

allow clearance for the heater assembly.

Remove complete Heater Assembly and discard.

Located on page 25 of instructions is

a template. Carefully cut out the

template and place it over the hole in

firewall behind glove box.

Drill (1) hole 5/16” dia., and

(1) hole 3/4” dia..

SEE NOTE BELOW BEFORE

DRILLING.

Caution: on the engine side of firewall there is a brake line. Do

not drill through. It may be necessary to carefully relocate this

line.

5/8” Dia. hole.

Brake line

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Žádné komentáře

Classic AutoAir Perfect Fit-Elite Series Provozní pokyny Strana 7