Classic AutoAir Perfect Fit-Elite Series Provozní pokyny stáhnout pdf (Strana 8)

Locate original wiring harness that was connected to

original blower switch. From the plug cut the YELLOW

wire and attach a ¼” insulated male spade connector.

All modifications to the vehicle are complete. You can now begin

installing your Classic Air “Perfect Fit Series” system.

Locate the original control head.

Remove original blower switch and the mode

control cables. Discard switch, switch knob and

the cables. Retain original hardware.

In the control sack kit you will find the control

switch mounting bracket. Attach bracket using

original screw that holds rear section of the

control head to the front section.

Locate the new Blower Switch, and (2) #6 x 3/8”

Pan Head Screws. Attach switch as shown.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Žádné komentáře

Classic AutoAir Perfect Fit-Elite Series Provozní pokyny Strana 8