Classic AutoAir Perfect Fit-Elite Series Provozní pokyny stáhnout pdf (Strana 7)

Remove fender and set aside for later

reinstallation.

Remove the blower and housing assembly. Discard and retain

(2) screws that are above and below the blower motor.

Locate the air inlet block off from the kit.

Using the original hardware attach over inlet

hole.

Reinstall the fender, body trim,

corner bumper assembly, turn

signal assembly and the light

bezel.

1 2 3 4 5 6 7 8 9 10 11 12 ... 30 31

Žádné komentáře

Classic AutoAir Perfect Fit-Elite Series Provozní pokyny Strana 7